Automotive terminal welding peripherals

 Screw car terminal welding:

The terminal of the screw connection method plays an important role in the electronics industry from time to time, and has always become an important component of the printed circuit board. Its structured more integrated wiring convenience and reliable screw connection and other features. Spring connecting terminal, spring connecting mode of printed circuit board terminal is divided into pull back spring connecting and butterfly spring connecting two kinds. The pull-back spring car terminal welding and screw terminal can be compatible with each other, greatly increasing the flexibility. Reliable connection, front connection, visible connection, low maintenance, no need to tighten.

The existing rail terminal RTB connection technology is applied to automobile terminal welding, and the circuit composed of electronic components is installed to complete the transmission coupling of photoelectric process. The center of automatic control is that the control unit must be reliably separated from the sensors and actuators, so as to avoid interference. Jett RPC optical block terminals can perform this function well, and ensure that the field signal matches the low voltage requested by the electronic control device. It can also be used as an interface element between the peripheral equipment of process control and the control, signal and conditioner device. And suitable for different voltage and power range.

Automobile terminal welding contact surface is large, and the contact pressure is large, and can be arbitrarily horizontal contact. With self-locking, seismic, anti-loose function. Test jacks can be installed without maintenance. Contact points are airtight and corrosion-resistant. Multi-strand wire allows no crimping end, can be directly connected. The use of bento is widely used worldwide with high contact pressure. Optical isolation terminal has the advantages of high switching frequency, no mechanical contact trembling, no wear switching, high insulation voltage, not afraid of vibration, not affected by position and long life under the control end signal loss, so it is widely used in the automatic control field.